You’ll immediately notice that the tension is tighter. Take the thin wooden dowel, which will serve as your shed rod, and slide it through the strings – under where the strings are crossed. The strings should be criss crossed around the middle of the loom. Separate the strings about a 1/4″ apart from each other and make sure the tension is even and tight, but not too tight, before tying a knot at the top of the frame.ĭouble check your loom from the side. Continue doing that, making a figure eight pattern each time.ĭepending on how wide you want your piece to be and how big your frame is, you can make as few as 10 loops and as much as 25. Īnd back down under and over the bottom of the frame. Loop the string under and over the top of the frame. Tie the end of your string into a double knot onto the bottom left of the frame. Because the warp is wound tightly around the frame, the yarn or string should be strong and not too thick or too thin. The warp is a set of lengthwise strings that are held, in tension, on a frame. To make your loom, start by adding the warp to the wooden frame.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |